Mitsubishi MOTION CONTROLLERS Q173DCPU Manuel d'instructions télécharger pdf (Page 153)

4 - 8

4 INSTALLATION AND WIRING

POINTS

(1) When installing the module, always insert the module fixing projection into the

module fixing hole of the base unit.

At that time, securely insert the module fixing projection so that it does not

come off from the module fixing hole.

If the module is forcibly installed without the latch being inserted, the module

connector and module will be damaged.

(2) When using the modules in a place where there is large vibration or impact,

screw the module to the base unit.

Module fixing screw : M3

12 (user-prepared)

Screw the Motion CPU module to the main base unit using supplied fixing

screws.

(3) Do not install/remove the module onto/from base unit or terminal block more

than 50 times, after the first use of the product. Failure to do so may cause the

module to malfunction due to poor contact of connector.

CAUTION

While pressing the installation lever located at the bottom of module, insert the module fixing

projection into the fixing hole in the base unit until it stops. Then, securely install the module with

the fixing hole as a supporting point. Incorrect installation of the module can cause an operation

failure, damage or drop.

When using the Motion controller in the environment of much vibration, tighten the module with a

screw.

Tighten the screw in the specified torque range. Under tightening may cause a drop, short circuit

or operation failure. Over tightening may cause a drop, short circuit or operation failure due to

damage to the screw or module.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 251 252

Pas de commentaire

Mitsubishi MOTION CONTROLLERS Q173DCPU Manuel d'instructions Page 153