Mitsubishi MOTION CONTROLLERS Q173DCPU Manuel d'instructions télécharger pdf (Page 151)

4 - 6

4 INSTALLATION AND WIRING

(4) Mounting surface

Mount the base unit on a flat surface. If the mounting surface is not even, this

may strain the printed circuit boards and cause malfunctions.

(5) Mounting of unit in an area where the other devices are mounted

Avoid mounting base unit in proximity to vibration sources such as large

magnetic contractors and no-fuse circuit breakers; mount those on a separate

panel or at a distance).

(6) Distances from the other devices

In order to avoid the effects of radiated noise and heat, provide the clearances

indicated below between the Motion controller and devices that generate noise or

heat (contactors and relays, etc.).

• In front of Motion controller : 100mm (3.94inch) or more

• On the right and left of Motion controller : 50mm (1.97inch) or more

Contactor, relay, etc.

100mm(3.94inch)

or more

50mm(1.97inch)

or more

50mm(1.97inch)

or more

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 251 252

Pas de commentaire

Mitsubishi MOTION CONTROLLERS Q173DCPU Manuel d'instructions Page 151