Mitsubishi RS232/485/LAN Serial Communication Control Manuel Page 321

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 349
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 320
19 FUJI
2-321
Chap.2
19.3 Connection Diagram
The connector types given in the Connection Diagrams are for the unit and not the cable.
For details regarding wiring, refer to "3 Important Points Regarding About Wiring" in
Chapter 1.
Connection Diagram 19-1:FLEX-PC series(Loader Port) - MICRO/I
PLC(RS-485/422) HG1F/2F/2S/3F/4F(RS-485/422)
Pin No.
Pin No.
Name
Name
HG1F
Connector
HG1F
Terminal
HG2F/
3F/4F
HG2S
- - FG Cover - 1 1
3 SDA TERM - - 9 -
4 SDB RDA(RD+) 2 3 10 32
5 RDA RDB(RD-) 7 4 16 33
6 RDB SDA(SD+) 1 1 11 30
8 SG SDB(SD-) 6 2 15 31
CS- 9 - 18 37
RS- 8 - 19 35
CS+ 4 - 21 36
RS+ 3 - 22 34
SG 5 5 7 29
Internal
termination
resistor
330-Ohm
D-sub, 9P connector socket type (HG1F)
D-sub, 25P connector socket type (HG2F/3F/4F)
D-sub, 37P connector plug type (HG2S)
Modular jack 8 Pin
Shield Wire
Connector Pin Layout for PLC side Modular jack
18
- There is no pin No. corresponding to TERM on the HG1F/HG2S. When inserting a
termination resistor, use a communication switch. For the setting of the switch, refer to "3
Important Points Regarding Wiring" in Chapter 1.
Connection Diagram 19-2: FLEX-PC series(Loader Port) + NN-CONV1 -
MICRO/I
Vue de la page 320
1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 348 349

Commentaires sur ces manuels

Pas de commentaire