Mitsubishi Q62DAN Manuel d'utilisateur télécharger pdf (Page 110)

9 - 2 9 - 2

MELSEC-Q

9 SPRING CLAMP TERMINAL BLOCK

(2) Cable Installation

Strip off about 6.5mm of the cable tip to install the bar solderless terminal to the

stripped part.

Connect the cable either by the (a) method or by the (b) method described

below.

(a) Connection by inserting the cable

Insert the wire with the bar solderless terminal into the circular shaped hole

and then force the wire into the hole until the connection check indicator

comes out. *1

Circular shaped hole

Connection Check

Indicator

*1: If the connection check indicator does not come out, the cable is not

connected to the module properly. Insert the cable until the connection

check indicator comes out.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 143 144

Pas de commentaire

Mitsubishi Q62DAN Manuel d'utilisateur Page 110