Mitsubishi PEN-2 Manuel d'utilisateur télécharger pdf (Page 19)

MITSUBISHI (19/29) AA084SB01--T2_02_00

(3) Touch Panel

a. Mechanical Characteristics

ITEM MIN. TYP. MAX. UNIT Remarks

Activation Force 0.05 -- 0.8 N *1)

Surface Scratching Write 100,000 -- -- characters *2)

Durability

Surface Pitting 10,000,000 -- -- touches *3)

Surface Hardness 3 -- -- H

JIS K5400,

ASTM D3363

*1) Stylus pen Input: R4.0 mm silicon pen

*2) Measurement for Surface area

-Input size 10

× 10 mm

-Input Character A to Z /minute

-Force: 2.45 N

-Stylus: R0.8 mm polyacetal tip

*3) Pit 10,000,000 hits on the Film with a R4.0 mm silicon pen

-Force: 3 N

-Speed: 2 hits/sec

b. Design Guide

-Avoid the design that Front-case overlap and press on the active area of the touch-panel.

-Give enough gap (over 0.5 mm at compressed) between the front case and touch-panel to

protect wrong operating.

-Use a buffer material (Gasket) between the touch-panel and Front-case to protect damage

and wrong operating.

-Avoid the design that buffer material overlap and press on the inside of touch-panel

viewing area.

-The flexible tail section should be designed to avoid stress from the front case and/or avoid

any bending stress to root of flexible tail section.

-Please avoid any strong forces, such as pen input in the area between display area and

insulated area (distance: >2mm), because it may cause damage to the film.

-When you handle the product, hold the product by its body. Do not hold by the FPC.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Pas de commentaire

Mitsubishi PEN-2 Manuel d'utilisateur Page 19