Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service télécharger pdf (Page 42)

OPERATING PROCEDURE PHOTOS

7. Removing the water cut, the indoor fan motor,

the indoor coil thermistor, and the line flow fan

(1) Remove the panel (Refer to 1.) and the corner box.

(2) Remove the power monitor receiver holder, the electri-

cal box and the nozzle assembly. (Refer to 3 and 4.)

(3) Remove the screw of the water cut and remove the

water cut.

(4) Remove the screws fixing the motor bed.

(5) Loosen the screw fixing the line flow fan.

(6) Remove the motor bed together with fan motor and

motor band.

(7) Remove the screw of the motor band.

(8) Release the hooks of the motor band. Remove the

motor band. Pull out the indoor fan motor.

(9) Remove the indoor coil thermistor from the heat

exchanger.

Install the indoor coil thermistor in its former position

when assembling it. (Photo 9)

(

) Remove the screws fixing the left side of the heat

exchanger.

(

) Lift the heat exchanger, and pull out the line flow fan

to the lower-left.

Photo 8

Photo 9

Photo 10

Photo 7

Indoor coil thermistor (main) RT12

Screws of the

motor bed

Screws of the

heat exchanger

Motor band

Indoor coil thermistor (sub) RT13

Screw of the line flow fan

Screw of the

motor band

Power monitor

receiver holder

Screw of the

electrical cover

Electrical box

Screw of the

V.A. clamp

Screw of the

water cut

1 2 ... 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Mitsubishi Mr.Slim MSZ-FE09NA