Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service télécharger pdf (Page 16)

8-6. i-see CONTROL OPERATION (MSZ-FE09NA MSZ-FE12NA)

The sensors constantly measure the room and floor/wall temperatures to automatically adjust to the set temperature by esti-

mating the temperature actually perceived by a person inside the room (“sensory temperature”).

Advantages

· The air inside the room is conditioned quickly to a comfortable condition.

· The room will not become too cold or hot even when the air conditioner is kept on

for a long period.

· The air conditioner will not overcool or overheat, which means you can save on electricity.

i-see control operation is activated when i-see button is pressed with a thin stick in manual COOL or manual HEAT mode.

NOTE: i-see control operation is activated when the remote controller is first used following replacement of the batteries

or resetting of the remote controller.

i-see control operation is cancelled when i-see button is pressed with a thin stick once again.

NOTE: If the conditioner is turned OFF without cancelling i-see control operation, i-see control operation is activated the

next time the air conditioner is turned ON.

i-see Sensor

i-see Sensor, which is installed on the upper of the air outlet of the indoor unit, is moved with the stepping motor and it

detects the floor/wall temperature.

i-see Sensor is installed here.

Enlarged view of i-see Sensor

i-see Sensor

• When AREA setting is not activated, the sensing range of i-see Sensor differs depending on the installation location of

the air conditioner.

Refer to "Remote controller in SERVICE FUNCTIONS".

• Install the front panel correctly after being removed for maintenance or service so that the floor/wall temperatures can

be measured correctly.

Installed at left Installed at center Installed at right

Installation

position

Image of sensing

range

Direction of sensor

Right Center Left

8-7. AREA ( ) SETTING (MSZ-FE09NA MSZ-FE12NA)

(1) Press OPERATE/STOP (ON/OFF) button to start the air conditioner.

(2) Press i-see button. (NOTE1)

(3) Press AREA button.

Each time the button is pressed, the area is changed in sequence:

(AUTO)

(LEFT) (RIGHT) Cancel

i-see Sensor moves intermittently, measuring the ﬂ oor and wall temperature.

(4) AREA setting is cancelled when the "cancel" is selected by pressing AREA button, or when WIDE VANE button is pressed.

NOTE1: AREA setting is only available during i-see control operation.

NOTE2: If AREA setting is cancelled, the vertical vane returns to the previously set position before AREA setting.

NOTE3:

The horizontal air ﬂ ow direction (WIDE VANE button), including horizontal SWING, cannot be set during AREA setting

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Mitsubishi Mr.Slim MSZ-FE09NA