Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service télécharger pdf (Page 38)

OPERATING PROCEDURE

PHOTOS

6. Removing the horizontal vane motor

(1) Remove the nozzle assembly. (Refer to 4.)

(2) Remove the screws of the horizontal vane motor unit, and

pull out the horizontal vane motor unit.

(3) Remove the screws of the horizontal vane motor unit cover.

(4) Remove the horizontal vane motor from the horizontal vane

motor unit.

(5) Disconnect the connector from the horizontal vane motor.

7. Removing the indoor fan motor and the line flow fan

(1) Remove the panel (Refer to 1.) and the corner box.

(2) Remove the sensor holder, the power monitor receiver P.C.

board holder, the electrical box (Refer to 3.) and the nozzle

assembly (Refer to 4.).

(3) Remove the screws fixing the motor bed. (Photo 9)

(4) Loosen the screw fixing the line flow fan. (Photo 10)

(5) Remove the motor bed together with fan motor and motor

band.

(6) Release the hooks of the motor band. Remove the motor

band. Pull out the indoor fan motor.

(7) Remove the indoor coil thermistor from the heat exchanger.

( ) Install the indoor coil thermistor (RT12) in its former posi-

tion when assembling it. (Photo 12)

(8) Remove the screws fixing the left side of the heat exchang-

er. (Photo 11)

(9) Lift the heat exchanger, and pull out the line flow fan to the

lower-left.

Photo 8

Screws of the horizontal

vane motor unit cover

Screws of the horizontal vane motor unit

Photo 12

Indoor coil thermistor (RT12)

Photo 9

Photo 11

Photo 10

Motor band

Screws of the

motor bed

Screw of the line

flow fan

Screws of the

left side of the

heat exchanger

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi Mr.Slim MSZ-FE09NA Manuel de service Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Mitsubishi Mr.Slim MSZ-FE09NA