Mitsubishi MOS1 Manuel d'utilisateur télécharger pdf (Page 5)

Français : voir la page 7 • Español: vea la página 13

5 69-2428EFS—03

Replacing system components

Portable central controller or outdoor sensor

To replace a Portable central controller or outdoor air sensor, install batteries

in the new component and follow the procedures on pages 2-3 to link it to the

wireless network.

Wireless Receiver, Equipment Interface Module, or Zone Panel

After installing a new wireless receiver, Equipment Interface Module, or zone

panel, you must re-set the Portable central controller to communicate with the

new equipment, as described below.

At the Portable central controller:

1 Press and hold the blank space (or arrow if

present) in the lower right corner of the screen

until the display changes (about 3 seconds).

2 Press REMOVE, then YES to disconnect from old

equipment.

3 Follow the procedure on pages 2-3 to link to new

equipment.

Removing all wireless devices:

1 Press and hold the CONNECT button on the wireless

receiver, Equipment Interface Module, or wireless adapter for 10 seconds.

2 To reconnect, see procedure on pages 2-3.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Mitsubishi MOS1 Manuel d'utilisateur Page 5