Mitsubishi DX-TL4509E(Z) Manuel d'instructions télécharger pdf (Page 16)

Attaching the HDD

Notice

• When you attach multiple HDDs, attach them in the

order of HDD 1 and 2.

Step

1 Attach the new HDD onto the HDD tray with 4

screws.

• Make sure to attach the HDD in the correct orientation.

Notice

• When attaching the HDD to this unit, use the supplied

screws.

Step

2 Insert the HDD tray halfway.

Step

3 Connect the cords.

Step

4 Insert the HDD tray completely.

Step

5 Attach the metal part.

• Align the upper side ﬁrst, then push the lower side

into the unit.

• Take care not to deform the springs.

• Pass the cord to be connected to the circuit board

through the hole in the metal part.

Step

6 Fix the metal part with 4 screws.

Step

7 Connect 2 cords to the circuit board on the metal

part.

Step

8 Check whether the HDD is connected properly.

1 Set the MODE rotary switch to any number from 0 to

2 While the TEST button is pressed, press the RESET

button.

3 After the unit boots up and the buzzer sounds, press

the TEST button.

The HDD test function is activated and tests each

HDD for 1 minute, and then the test results are

shown by the ACCESS indicator.

When the indicator illuminates green, the connection

is completed successfully.

When the indicator blinks red, the HDD is not

connected properly.

When the indicator illuminates red, the HDD is not

identiﬁed properly.

Replacing the HDD (continued)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi DX-TL4509E(Z) Manuel d'instructions Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement Mitsubishi DX-TL4509E(Z)