Mitsubishi HC6800 Manuel d'utilisateur télécharger pdf

LCD Projector

HC6800

Controlling the projector using a personal computer

This projector can be controlled by connecting a personal computer with RS-232C terminal.

PC-controllable functions:

• Turning the power ON or OFF

• Changing input signals

• Inputting commands by pressing the buttons on the control panel and remote control

• Menu setting

Connection

RS-232C cable

SERIAL

D-SUB 9-pin

To RS-232C

terminal

Important:

• Make sure that your computer and projector are turned off before connection.

• Boot up the computer rst, and then plug the power cord of the projector.

(If you do not follow this instruction, the Com port may not function.)

• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.

1) Interface

PROTOCOL RS-232C

BAUD RATE 9600 [bps]

DATA LENGTH 8 [bits]

PARITY BIT NONE

STOP BIT 1 [bit]

FLOW CONTROL NONE

This projector uses RXD, TXD and GND lines for RS-232C control.

For RS-232C cable, the reverse type cable should be used.

2) Control command diagram

The command consists of the address code, function code, data code, and end code. The length of the command

varies among the functions.

Address code Function code Data code End code

HEX 30h 30h Function Data 0Dh

ASCII ‘0’ ‘0’ Function Data

[Address code] 30h 30h (In ASCII code, ‘0’ ‘0’) xed.

[Function code] A code of each xed control move.

[Data code] A code of each xed control data (number) and not always indicated.

[End code] 0Dh (In ASCII code, ‘ ’) xed.

1 2 3 4 5 6

Résumé du contenu

Page 1 - LCD Projector

1LCD ProjectorHC6800Controlling the projector using a personal computerThis projector can be controlled by connecting a personal computer with RS-232C

Page 2 - 3) Control sequence

23) Control sequence(1) Send the command from the personal computer to the projector.(2) The projector will send a return command after it re

Page 3 - 8) Reading command diagram

36) Remote commands (Not executable in stand-by mode. When the remote commands are sent while the splash screen is being displayed, the

Page 4

4ASCII HEXFunction Data (Receive) Function Data (Receive)INPUT S-VIDEO vI v2 76h 49h 76h 32hPOWER ON/OFF INPOSSIBLE vPK 0 76h 50h 4Bh 30hPOWER ON/

Page 5 - How to set the value

5ITEM ASCII HEX VALUETEST PATTERN TP 54h 50h 0 (OFF), 1 (CROSS HATCH), 2 (WHITE), 3 (BLACK)FOCUS/ZOOM LOCK FZL 46h 5Ah 4Ch 0 (OFF), 1 (ON)LENS SHIF

Page 6

6[Example 3] When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed in quotation marks are ASCII

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi HC6800 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Projecteurs Mitsubishi HC6800. HC6800 - Mitsubishi Presentation Products Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Mitsubishi HC6800