Mitsubishi FL7000LU Manuel d'utilisateur télécharger pdf (Page 11)

EN-11

Enter “9” and press the Enter key.

The setting screen is shaded and the setting is updated.

• It takes about 10 seconds for the setting to be

updated. Don’t perform communication during this

period.

Save and exit

•

Because the password, display language, LAN control, and PJLink

™

certiﬁcation are set using the telnet function,

you can also set them on the command prompt window of the personal computer. Enter the following command and

press the Enter key.

> telnet [IP address you set] 9999 [“>” shows a prompt.]

When setting menu appears, perform the setting procedure as described above.

(Note)

Check that the port number “9999” isn’t blocked by the ﬁrewall.

Preparation/SetUp (continued)

Enter “5” and press the Enter key.

• When you don’t use PJLink™ protocol

communication, skip this item. (See page 16 for

PJLink™.)

To enable the PJLink™ certiﬁcation, enter “1” and

press the Enter key. To disable it, enter “0” and press

the Enter key. (Default is ON (1).)

Setting the PJLink™ certiﬁcation (PJLink certiﬁcation Mode)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Mitsubishi FL7000LU Manuel d'utilisateur Page 11