Mitsubishi MUT-II Manuel du propriétaire télécharger pdf (Page 12)

1-4. Harness Connection Method

Harness Connection Method

Recommended harness connection sequence

[1] Start the PC.

[2] While the PC is starting, connect the USB cable to the V.C.I.

[3] After the PC boots to the M.U.T.-III main screen, connect the USB cable to the PC.

Note: Disconnect the USB cable from the V.C.I. after the PC has shut down. However, if the

USB cable is disconnected during use, a warning message indicating device

disconnection such as that shown in Figure 1 appears. Close the message display by

pressing the OK button.

[4] Select the appropriate M.U.T.-III main harness. Connect it to the V.C.I.

[5] Connect the M.U.T.-III main harness to the vehicle data-link-connector. (See Figure 2)

Note: Disconnect the harnesses by performing the above steps in the reverse order.

[6] Turn the V.C.I. power switch ON and verify that the indicator lamp located in the upper right area

of the LCD screen is green.

[7] Turn the vehicle ignition switch ON, and begin the diagnostic process from the M.U.T.-III system

screen.

Note: In case the version of V.C.I. and the firmware version of V.C.I., which are mismatch, a

dialog box appears on PC screen, and the V.C.I. version upgrade process begins. This

upgrade typically only occurs once per M.U.T.-III system upgrade. Normal V.C.I.

upgrades take about 1 minute. If a version upgrade error occurs, restart the V.C.I. by

turning V.C.I. power OFF then, while pressing the Esc button, turn the V.C.I. power switch

ON and begin the diagnostic process again.

[5][2][3] [4]

[6]

[7]

[1]

Connect the trigger harness to the

V.C.I. trigger terminal.

(Not available in US)

Connect the measurement adapter to the V.C.I.

trigger terminal. Insert the measurement leads to

the adapter. For best results, match the test lead

colors with those on the adapter.

<Connecting the Measurement Adapter

and Measurement Probe>

<Fig. 1>

<Fig. 2>

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 102 103

Pas de commentaire

Mitsubishi MUT-II Manuel du propriétaire Page 12