Mitsubishi SKM40ZA Manuel d'installation télécharger pdf (Page 18)

- 15 -

Indication section of air conditioner

RUN lamp (green)

ON during running

Heat-retaining

Running

Stop

1.5 sec.

0.5 sec.

ON during HI POWER/JET running

TIMER lamp (yellow)

ON during timing operation

HI POWER/JET lamp (green)

Receiving part of remote controller

Receives signals from remote controller

ON/OFF button

Press this button to begin

running; press it again to stop

running.

POWER SAVE lamp (green)

ON during Power Save running

Temp. displaying lamp (olivine)

It displays the room temperature or

set temperature. (Each time the

remote controller is pressed, the

temperature set with the remote

controller flashes for 10 seconds,

and then the room temperature is

displayed.

Opening the air inlet grille

Put your hands on the indentations on both sides, raise the grille towards yourself, and stop at the opening position of

about 60°.

Closing the air inlet grille

Gently push both sides and then gently push the central portion.

Removing and mounting the air inlet grille

To remove the air inlet grille to clean the inside, open it

at the position of about 65° and pull it towards yourself

to remove the grille.

To mount the air inlet grille, insert the mounting arm

onto the pin roll and close the grille.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 121 122

Pas de commentaire

Mitsubishi SKM40ZA Manuel d'installation Page 18