Mitsubishi DX-TL4516U series Manuel d'instructions Page 109

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 131
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 108
106
If problems with the unit persist even after you’ve followed the suggestions below, disconnect the power cord and contact the
retailer from whom you purchased the unit.
INSTALLATIONRECORDING
PageConsult the followingDescription of problem
-
12,60,61
12
16
12,60,61
12
17,83
18
62
77
91
12,60,61
12
14
77
58
54,55
77
50
12
18
Is the power cord properly plugged in?
Is the LOCK indicator light on?
Is the TIMER indicator light on?
Is the MAIN switch on the rear of the unit set to “OFF” ?
Is the LOCK indicator light on?
Is the POWER indicator flashing? (The unit cannot be operated while
the POWER indicator is flashing.)
The safety features may be in operation.
Reset the unit by pressing the RESET button on the rear panel using a
ballpoint pen or similar object, and then turn the power on again.
Are the monitor and camera(s) connected correctly?
Is the unit receiving an input signal from the selected camera?
Check this by displaying the SPLIT16 screen.
Is the connecting cord connected correctly?
Is the camera’s focus adjusted correctly?
Is repeat recording set to "Repeat Off"?
The recording starts after the time set for recording rate is passed.
Was the unit stopped during that time?
Is the LOCK indicator light on?
During normal recording, alarm recording, and emergency recording,
press the REC/STOP button for more than 2 seconds.
Is timer recording in progress?
To stop timer recording, press the TIMER button for more than 2
seconds.
Is repeat recording set to "Repeat On"?
Are the date and current time set accurately?
Are the recording start-/end-times and the recording rate set correctly?
Is repeat recording set to "Repeat Off"?
Is the recording rate for alarm recording set to “– – –”?
Is the recordable capacity for alarm recording area full?
Is the unit in timer recording stand-by mode?
(Is the TIMER indicator light on?)
Are the peripheral switches, etc., connected correctly?
The unit does not be turned
on.
Power is on, but the unit
does not operate.
Pictures are not appearing
on the monitor.
The quality of the monitor
picture is poor.
The unit does not start
recording.
The unit does not stop
recording.
The unit does not repeat the
recording.
The unit does not perform
timer recording.
The unit does not perform
alarm recording.
Troubleshooting
Vue de la page 108
1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 130 131

Commentaires sur ces manuels

Pas de commentaire